HyPhy message board
http://www.hyphy.org/cgi-bin/hyphy_forums/YaBB.pl
Methodology Questions >> How to >> GARD and PARRIS via command line HyPhy
http://www.hyphy.org/cgi-bin/hyphy_forums/YaBB.pl?num=1382472023
Message started by Maurice on Oct 22nd, 2013 at 1:00pm

Title: GARD and PARRIS via command line HyPhy
Post by Maurice on Oct 22nd, 2013 at 1:00pm
Hi HyPhy users,

A quite simple question for which I cannot find an answer unfortunately:

Is it possible to run the GARD analysis then the PARRIS test via the command line version of HyPhy? And how to do so?

The command line version of HyPhy has been installed in the cluster we have at the university (Linux). I have found the TemplateBatchFiles directory within the cluster where GARD.bf and PARRIS.bf are but I am not sure what to do next...

What do I need to type in?
Is there any documentation about how to use this version of HyPhy??

Thanks in advance!

Best

Title: Re: GARD and PARRIS via command line HyPhy
Post by Sergei on Oct 31st, 2013 at 3:22pm
Hi Maurice,

Try following the example on automating HyPhy analyses here Multimedia File Viewing and Clickable Links are available for Registered Members only!!  You need to Login Login

Sergei

HyPhy message board » Powered by YaBB 2.5.2!
YaBB Forum Software © 2000-2024. All Rights Reserved.